Making a Blackmagic Probe

Using the STM32F103C8T6 minimum system development board described in the hardware section.
Using the serial upload method using described previously.

We need a copy of the blackmagic firmware to upload. - Source - Source – Old Pre-built Binary

If you are setup to compile the source then it is available on GitHub, otherwise I found the older prebuilt binary to work for me so far.

Connect Up USB/Serial Converter to the board you are going to turn into a BMP.
Set Jumpers (BOOT0 = 1, BOOT1=0)
Reset Board

$ ./ -e 	
$ ./ – w blackmagic.bin	

Set Jumpers (BOOT0 = 0, BOOT1 = 0)
Reset Board

Disconnect USB/Serial Converter
Plug in microUSB and connect to PC (Linux in my case)

$ dmesg

usb 7-3: new full-speed USB device number 27 using ohci-pci
usb 7-3: New USB device found, idVendor=1d50, idProduct=6018
usb 7-3: New USB device strings: Mfr=1, Product=2, SerialNumber=3
usb 7-3: Product: Black Magic Probe (JC66CoreBoard), (Firmware v1.6-rc0-77-gb8881fd)
usb 7-3: Manufacturer: Black Sphere Technologies
usb 7-3: SerialNumber: C1C19AFD
cdc_acm 7-3:1.0: ttyACM0: USB ACM device
cdc_acm 7-3:1.2: ttyACM1: USB ACM device

If all goes well the device should enumerate as something like above.

ttyACM0 – Virtual Serial Port GDB Interface
ttyACM1 – Virtual Serial Port USB/UART

So now we have a working BMP clone board to use. The next step to doing something useful will be to install the toolchain.

Back to Index

One Reply to “Making a Blackmagic Probe”

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.